FBS-014 Fitting Instructions — Defender 110 Tdci 2011-2016 LHD No bias valve, Non ABS
Bag-by-bag fitting instructions for your complete braided brake line kit. Every line is supplied in a numbered bag — work through them in order and check each run before you tighten anything.
| Model | Engine | Years | Drive | Spec | SKU |
|---|---|---|---|---|---|
| Defender 110 | Tdci | 2011-2016 | LHD | No bias valve, Non ABS | FBS-014 |
Before you start
Brakes are safety critical. Read the brake & clutch line fitting and safety guide in full before fitting — it covers routing and slack, tightening sequence, torque figures and bleeding. If you are not confident, have the kit fitted by a competent garage.
This kit starts at bag 2
Your vehicle has female front flexi fittings, held to the chassis bracket by a retaining C-clip. Our front caliper hard lines have a female connector with a 180-degree angled stem, which mates only with the earlier male fitting — that bend cannot be formed on a male stem, so caliper hard lines are not supplied with this kit.
There is no bag 1 in this kit. Bag numbering is unchanged so it matches the rest of the range. A conversion route is available — see the male and female fitting explanation page.
Download these instructions
A print-ready A4 PDF of this page — fitment details, the kit layout diagram and the full bag schedule — to take out to the vehicle.
6 numbered bags
3 Line flexi kit
From Chassis Brackets → To 2 x Front swivel bracket 1 x T-piece on rear axle
1 Line
From Master Cylinder Bottom Port → To O/S Front Chassis Bracket
1 Line
From Master Cylinder Front Port → To N/S Front Chassis Bracket
1 Line
From Master Cylinder Rear Port → To Rear flexi chassis bracket
1 Line, 3 x Axle clips, (If caliper 1 x Banjo bolt and 2 copper washers which connect to the caliper)
From T-piece → To O/S/R brake caliper
1 Line, 2 x Axle clips, (If caliper 1 x Banjo bolt and 2 copper washers which connect to the caliper) 1 x T-piece
From T-piece → To N/SR brake caliper
Product page
Complete Braided Brake Line kit for Land Rover Defender 110 TDCi 2011-2016 LHD No Bias, Non ABS
All kit instructions are listed on the fitting instructions page.
Stuck on something?
If anything does not match what is in front of you, stop and ask before fitting.
Email pioneer4x4@outlook.com · Tel 01404 643149