FBS-054 Fitting Instructions — Discovery 1 300Tdi 1994-1998 RHD Bias valve, Non ABS
Bag-by-bag fitting instructions for your complete braided brake line kit. Every line is supplied in a numbered bag — work through them in order and check each run before you tighten anything.
| Model | Engine | Years | Drive | Spec | SKU |
|---|---|---|---|---|---|
| Discovery 1 | 300Tdi | 1994-1998 | RHD | Bias valve, Non ABS | FBS-054 |
Before you start
Brakes are safety critical. Read the brake & clutch line fitting and safety guide in full before fitting — it covers routing and slack, tightening sequence, torque figures and bleeding. If you are not confident, have the kit fitted by a competent garage.
Download these instructions
A print-ready A4 PDF of this page — fitment details, the kit layout diagram and the full bag schedule — to take out to the vehicle.
9 numbered bags
2 x Front Caliper hard line replacements
From Swivel bracket → To Caliper
3 Line flexi kit
From Chassis Brackets → To 2 x Front swivel bracket 1 x T-piece on rear axle
1 Line
From Back O/S bias valve port → To O/S front chassis bracket
1 Line
From Front master cylinder port → To rear underside port on bias valve
1 Line
From Rear master cylinder → To front underside port on bias valve
1 Line
From Back N/S bias valve port → To N/S front chassis bracket
1 Line
From Front upper port on bias → To Rear chassis flexi bracket
1 Line, 3 x Axle clips, (If caliper 1 x Banjo bolt and 2 copper washers which connect to the caliper)
From T-piece → To N/S/R brake caliper
1 Line, 2 x Axle clips, (If caliper 1 x Banjo bolt and 2 copper washers which connect to the caliper) 1 x T-piece
From T-piece → To O/SR brake caliper
Product page
Complete Braided Brake Line kit for Land Rover Discovery 1 300Tdi 1994-1998 RHD Bias Valve Non ABS
All kit instructions are listed on the fitting instructions page.
Stuck on something?
If anything does not match what is in front of you, stop and ask before fitting.
Email pioneer4x4@outlook.com · Tel 01404 643149