FLK-005 Fitting Instructions — Defender 130 300Tdi 1994-1998

Pioneer 4x4 · Fitting InstructionsFLK-005

Defender 130 300Tdi 1994-1998

Bag-by-bag fitting instructions for your Pioneer 4x4 braided fuel line kit. Every line is supplied in a numbered bag — offer the kit up first, then work through the bags in order and check each run before you tighten anything.

Fitment

Model	Engine	Years	Fuel system	SKU
Defender 130	300Tdi	1994-1998	Diesel fuel lines	FLK-005

Read first

Before you start — fuel is flammable

Work in a well-ventilated area away from any source of ignition. Offer the new lines up to the vehicle and check them against the originals for length before removing anything. Drain the system, catch any spillage and keep fuel off the paintwork.

Fit using the new copper washers supplied, route without kinks or twists, and make sure every line sits in its original brackets and rubber bushes clear of the chassis and any moving parts. Bleed the system per the manufacturer's guidelines with fresh fuel, and check every connection for leaks before driving. If you are not confident, have the kit fitted by a competent garage.

Before you fit

Remove the original nuts and olives

On the hardline tails at the fuel tank, lift pump and injection-pump return you will find the original nuts and olives that took the OEM fuel lines. The new Pioneer 4x4 fittings use a different thread, so these must come off.

You can carefully cut the olive to free the nut, but this risks damaging the tail — we recommend fitting new parts to take the new nuts and olives.